Plug in your AzaanBox
Connect the AzaanBox to power using the supplied cable. Wait a few seconds for the device to start up — no screen or TV is needed.
Connect your phone to the AzaanBox hotspot
On your phone, go to Settings → WiFi and connect to the following network:
If prompted, tap “Connect without internet” or “Stay connected”.
Open the setup page
Once connected to the AzaanBox hotspot, scan the QR code with your phone camera, or open your browser and go to:
QR code for 192.168.43.1:8080
Select your WiFi network
The setup page will show a list of nearby WiFi networks. Select your WiFi from the list. If it doesn’t appear, tap Refresh network list.
Enter the WiFi password
Type in your WiFi password and tap Connect Device. The AzaanBox will attempt to connect — this takes about 20–30 seconds.
Wait for confirmation
You will hear the AzaanBox say “WiFi connected successfully. Opening AzaanBox.” — this confirms the connection was successful.
The AzaanBox will start streaming automatically. Setup is complete. ✅
Check your device & change stream
At any time you can check if your AzaanBox is online and change the stream. Scan the QR code or open the link below in any browser:
Device status page — you will be asked to enter your MAC address, found on the label on the bottom of the AzaanBox.
stream.letsweby.com/deviceQR code for device status page